Used on the Anet A6 which comes with a 40mm throat. This made the nozzle a few mm too high even with the build plate fully up, but a careful bend down of the z-switch lever arm fixed that. It puts the cooling duct outlet closer to the nozzle, but that hasn't caused any issues so far. Have used the 35mm throat without any problem since I replaced the broken 40mm one.

Used on the Anet A6 which comes with a 40mm throat. This made the nozzle a few mm too high even with the build plate fully up, but a careful bend down of the z-switch lever arm fixed that. It puts the cooling duct outlet closer to the nozzle, but that hasn't caused any issues so far. Have used the 35mm throat without any problem since I replaced the broken 40mm one.

Used on the Anet A6 which comes with a 40mm throat. This made the nozzle a few mm too high even with the build plate fully up, but a careful bend down of the z-switch lever arm fixed that. It puts the cooling duct outlet closer to the nozzle, but that hasn't caused any issues so far. Have used the 35mm throat without any problem since I replaced the broken 40mm one.

Thanks!

Thanks!

Thanks!