Klantbeoordelingen

Schrijf een beoordeling
  • Alle beoordelingen(14)
  • Afbeeldingen
  • Videos
  • Ster
    • Ster(14)
    • 5 Ster(14)
    • 4 Ster(0)
    • 3 Ster(0)
    • 2 Ster(0)
    • 1 Ster(0)
Sorteren op:
Top recensie
  • Top recensie
  • Meest nuttig
  • meest recent
Recensies alleen uit uw land (United States)
|
Toon origineel

Een deel van de recensie is automatisch vertaald.

  • 24/09/2019

    Nice drivers. Bought these with the skr v1. 3 board to quiet down my Ender 3 Pro. Will install them as soon as I have the chance.

    Reacties
    Toon origineel
  • 11/06/2019

    These are definitely value for money. However being v1.0 the TMC2130s are CONFIGURED TO WORK IN STANDALONE MODE ONLY. As such tying the CFG1 (SDI) pin to GND runs it in spreadCycle mode (16x microstepping) and keeping it open runs the driver in stealthChop (16x microstepping) mode. Overall this was definitely a huge upgrade for my printer. To run the chips in SPI mode, the chip has to be modded just like the FYSETC v1.0 boards. If you want SPI features then its worth skipping all the hassle and buying the v1.1 or similar drivers.

    Reacties
    Toon origineel
  • 09/06/2020

    great pleasure airmail I received in 52 days, Thank you for the product is super :))

    Reacties
    Toon origineel
  • 20/04/2020

    looks like described 🙂

    Reacties
    Toon origineel
  • 08/04/2020

    looks as described 🙂

    Reacties
    Toon origineel
  • 22/06/2019

    güzel teşekkürler

    Reacties
    Toon origineel
  • 09/06/2020

    great pleasure airmail I received in 8 days, Thank you the product is super :))

    Reacties
    Toon origineel
  • 14/02/2020

    works the way it should

    Reacties
    Toon origineel
  • 24/01/2020

    These are a bit tricky to get up and running when using SPI. Look elsewhere if you're thinking of using SPI and only buy these if using standalone mode. There are other great stepperdriver breakouts that come prepared for SPI. Nevertheless, for SPI they are great if you fancy doing some soldering work.

    Reacties
    Toon origineel
  • 29/11/2019

    Нормальные драйвера. Заточены под стандалон - для переделки под SPI необходима ловкость рук и паяльное кунг фу. Пока работают как должны. С платой SKR 1.3 (переделал под SPI)

    Reacties
    Toon origineel
Show:

    Totaal 0 Pagina's

    Ga naar pagina

    recommendation for you
    • US$3.00
    • US$80.99
    • US$55.00
    • US$11.99
    • US$34.99
    • US$419.00
    • US$63.99
    • US$64.99
    • US$29.99
    • US$25.99
    • US$45.00
    • US$39.00
    • US$17.99
    • US$16.99
    • US$16.99
    • US$11.49
    • US$21.99
    • US$469.99