Klantbeoordelingen

4.89 van5
Schrijf een beoordeling
  • Alle beoordelingen(36)
  • Afbeeldingen
  • Videos
  • Ster
    • Ster(36)
    • 5 Star(32)
    • 4 Star(4)
    • 3 Star(0)
    • 2 Star(0)
    • 1 Star(0)
Sorteren op:
Top recensie
  • Top recensie
  • Meest nuttig
  • meest recent
Recensies alleen uit uw land (Netherlands)
  • June-06 2018 02:15:28

    Good condition arrived in safe and all parts is ok! Good value/quality ratio. Thank you! :)

    Reacties
  • January-19 2021 13:35:41

    prima en snel

    Reacties
  • January-12 2021 21:08:07

    Very happy with this item!

    Reacties
  • December-14 2020 12:08:44

    exactamente o que pretendia

    Reacties
  • November-14 2020 05:48:42

    As described. Arrived in reasonable time.

    Reacties
  • October-28 2020 15:34:02

    ok

    Reacties
  • October-26 2020 07:29:56

    OK

    Reacties
  • August-08 2020 01:08:18

    Excellent component, easy to use with Arduino.

    Reacties
  • February-04 2020 12:54:20

    Can't go wrong with these

    Reacties
  • January-30 2018 19:54:54

    The encoder is OK, but the switch is NOT brought out to any pins, which means soldering, no matter what you do. Since the 'C' pin is directly connected to the GND pin, you can cut the trace on the back between the two pins, and wire one side of the switch to the old GND pin, and then wire the other side of the switch to either 'C' (the new GND pin) or to VCC. Normally you'll want the switch to GND as most micros have internal pull-up resistors, and it's less to wire in later. I've added a schematic

    Reacties (1)
Show:

    Total 0 pages

    Go to page

    Go

    Wellicht ben je ook geïnteresseerd in

    recommendation for you
    • US$2.99
    • US$5.52
    • US$8.99
    • US$2.13
    • US$1.99
    • US$6.99
    • US$15.13
    • US$9.44
    • US$1.99
    • US$2.99
    • US$12.99
    • US$1.99
    • US$1.99
    • US$3.14
    • US$2.99
    • US$4.70
    • US$2.09
    • US$4.78